The 2014 Ram 1500 P26AB code indicates that there is an issue with the engine coolant bypass valve. According to the code definition, it is likely stuck and needs to be replaced. The cost of a new valve can range from $70-$90, however if one opts to replace it themselves, they should first remove the air filter box assembly on the passenger side under the hood for easier access.
An 8mm socket will be necessary to remove bolts while thre connected hoses and electrical connector should be clamped prior to removal in order to prevent unnecessary coolant loss. A 13mm ratchet wrench will then need to be used in order to remove both the assembly and harness. It is important that these steps are followed carefully as improper replacement may lead to further issues down the line.
What is the Dtc P26ab code?
If your Dtc P26ab code is indicating a problem with the engine coolant bypass valve, there are a few things you can do to try and resolve the issue. First, make sure that the valve is properly installed and functioning by checking for any leaks or damage. If the valve appears to be in working order, next test it by turning the key to the “on” position but leaving the car in Park and waiting 10 seconds. If no coolant flows through the valve when this is done, it likely means that something is blocking the valve’s flow. One possible culprit could be debris buildup inside of the valve or a clog in one of its tubes. If these measures fail to fix the issue, then your car may require replacement of the engine coolant bypass valve.
Other article: P0603 Code 7.3 Powerstroke
What are the symptoms of a Dtc P26ab code?
If your car has a “Dtc P26ab code,” then there is a very good chance that the engine coolant bypass valve (ECBV) is stuck open. This can cause a variety of problems with your engine, including decreased fuel efficiency, difficulty starting the car, and even a possible stall. In order to determine if your ECBV is stuck open, you’ll need to take your car into a mechanic. However, if you notice any of the following signs or symptoms, it’s probably time to get the Yanukovych fixed:
- Difficulty starting the car
- Poor fuel economy
- A stall in the vehicle
Read also: Replaced Camshaft Position Sensor But Still Get Code
What is the cost of a new engine coolant bypass valve?
The cost of a new engine coolant bypass valve can vary depending on the make and model of your car. However, in general, a new valve will cost around $100. If your car has an A-pillar airbag, the cost of the replacement part may be higher due to additional labor required.
